Since the cradle is already mounted to the wall, guide the AP towards the top tab and i nsert the top tab into the AP ’s slot. To attach the AP to the mount cradle properly, line up the top edge of the AP with the top tab of the mount cradle. The AP attaches to the mount cradle with two tabs on the cradle that insert into the AP, and is secured to the cradle using one screw. Where you have already installed the mount cradle.) (This section applies to wall and/or solid ceiling, drop ceiling or electrical junction box mount If mounting your AP to a dropped ceiling, skip to the "Power the AP " section. The mount cradle can then be held with one hand while the other hand holds a screwdriver. Tip: Pre-assemble rubber spacers and screws to the mount cradle. Attach the mount cradle to the T-rail clips using the mount cradle holes (marked with a “T“).
Tighten the set screws on the T-rail clips to secure the clips using a 5/64”(2 mm) hex key.Using the dashed lines on the mount cradle template as a guide, set the proper spacing of the T-rail clips on the T-rail.The black foam pads should be compressed slightly after installation. Attach the T-rail clips to the T-rail by rotating them and snapping them into place as shown.6-32x7 mm screws only used for recessed rail mount (uncommon).Drop ceiling mounting clips with set screws.The accessory kit can be used to mount to most 9/16”, 15/16” or 1 ½” T-rails. To mount your AP on a drop ceiling T-rail, use the included drop ceiling mounting accessory kit. Designed for highest capacity and highest density, the MR52 and MR53 meet the need of the most demanding environments. They both also include a third radio dedicated to optimizing the RF environment and securing the airwaves. The Cisco Meraki MR52 and MR53 are dual-band enterprise class 802.11ac Wave 2 cloud-managed access point. Verify Device Functionality and Test Network Coverage.Electrical Junction Box Mount Using mount cradle.Wall or Solid Ceiling Mount Using mount cradle.Collect Additional Hardware for Installation.
0 kommentar(er)
